Email:ds5898@163.comWuxi Wanchuan Environmental Equ-Ipment Technology Co.,Ltd

Wuxi Wanchuan Environmental Equ-Ipment Technology Co.,Ltd

Control function and installation requirements of half-bridge peripheral transmission scraper

The driving gear reducer of the half-bridge peripheral drive scraper is set on the driving axle and is mainly fixed on the end beam through the moment arm and the compression spring overload protection device during the operation. The work of the half-bridge peripheral transmission scraper When the torque exceeds the rated output torque of the reducer, the torque arm at the output end of the reducer moves, and the spring in the overload protection device is compressed. The pressure lever approaches the sensing distance of the planar non-contact induction switch and instantaneously cuts off the power, and at the same time, sends a fault signal. To protect the device from damage.

The half-bridge peripheral drive scraper is mainly made of high-quality stainless steel plates and profiles during the production process. The mud scraper scrapes the sludge from the bottom of the tank to the sludge tank in the bottom of the tank, and is installed in this tank. The suction pipe is used to eliminate the water level difference in the sludge tank and press it into the pipeline collecting mud tank.

The slag slag board and articulated slag scraper of the half bridge type peripheral transmission scraper are mainly made of high-quality stainless steel plate. Generally, the slag board is installed in the lower part of the main girder, and the distance from the pool The end of the core is close to the center guide tube, and the gap between the other end and the slag bucket is not more than 5mm. It is installed on the main beam at a certain angle to ensure that the scum in the pool is scraped from the center of the pool to the articulated scrap scum. The articulated scraper scrapes it into the hopper bowl and discharges the scraped scum out of the tank.

The control box of the half-bridge peripheral transmission scraper is an outdoor type. It is mainly installed on one side of the main beam to a certain extent. The cabinet is made of stainless steel plate. When it is used, its control box has local control equipment. Open and stop, and can provide all the running signals and remote control functions of the equipment to the central control room.

Quartz sand or rubber particles in the paving of the half-bridge peripheral drive scraper need to be kept dry to facilitate the flow of quartz sand or rubber particles. After the quartz sand or rubber particle laying is completed, a hard brush or a light load drag heavy brush may also be used, and the brush back and forth makes the quartz sand drop fully dense.

http://www.shallowairfloatation.com/


Copyright © Wuxi Wanchuan Environmental Equ-Ipment Technology Co.,Ltd. All Rights Reserved.
QR Code
[[Html_Custom]]